butées à billes

Contacter maintenant

Thrust ball bearings are classified into those with flat seats or aligning seats depending on the shape of the outer ring seat (housing washer). They can sustain axial loads but no radial loads. For Single-Direction Thrust Ball Bearings, pressed steel cages and machined brass cages are usually used The cages in Double- Direction Thrust Ball Bearings are the same as those in Single-Direction Thrust Ball Bearings of the same diameter series.

Available in two designs: single direction and double direction.To accommodate initial misalignments in an assembly both designs are available with spherical aligning seats or aligning seat washers.High quality steel-ultra clean steel to extend bearing life by up to 80%.Advanced Grease Technology — NSK lubricants that can extend grease life and performance.High Grade Balls — Quiet and smooth operation even at high speed.Optional seating rings take initial misalignment.

butées à billes Bore Dia Outer DIa Width Size
SKF 51202V/HR22Q2 butées à billes 34,925 25,654 mm 0,8 mm 73,025
INA FTO10 butées à billes 18 mm 100 mm 65 mm 100
ISO 51116 butées à billes 19 mm 19x27x16 17,4 kN 16 000 r/min
INA 2458 butées à billes 260 ISO 80 mm 260x480x80
Toyana 52413 butées à billes P 62 R-25 WF 4 mm YEL 205-2F RIS 205
140 mm x 250 mm x 68 mm SKF NJ 2228 ECML butées à billes 18 mm 21 4,85 kN 12 mm
SKF 51306V/HR22Q2 butées à billes 2,98 150 mm 4,8 mm 138 mm
NACHI 54210U butées à billes 3600 r/min ZEN 130x165x18 43 kN
40 mm x 72 mm x 15 mm SNFA BS 40/72 /S 7P62U butées à billes 7,000 31171504 4547359551754 Metric
160 mm x 290 mm x 48 mm SKF NJ 232 ECML butées à billes 0.6 - 23 mm 35 mm
ISO 234740 butées à billes 50x115x34 4.6 kN 0.6 mm M8
ZEN 51204 butées à billes 30 23,8 mm WB1630112 30 mm
1/11